Quote:
Originally Posted by Sunny2022
Hi
2013 BMW X3 - Car has 47,000 miles
I get jerk during start and stop.
Error Code
P18D7 Ratio Monitoring Shift From Gear 7
1 Dynamic Stability Control Code
4809AB global voltage supply
I had transmission fluid check, it was low. topped it up
Changed all 4 spark plugs.
Changed battery .
Still getting jerk during accelerating and stopping
Now getting following errors
1 Central Gateway Module CodCD1400
Reception no error memory lock
1 Dynamic Stability Control Code
4809AB global voltage supply
1 Instrument Cluster Code
E11474
HISTORY
Message (Display Check-Control Bypass EMF, 0x36F) missing, receiver instrument
cluster, sender EMF
7 Rear Electronics Module Codes
800E8B
HISTORY
Clamp 30A Connector faulty
800E8C
HISTORY
Clamp 30B Connector faulty
030015
ACTIVE
FH FA: invalid characteristic curve, no Standardisation available
03001C FH FA: No Initialisation because of invalid marginal condition
030095
ACTIVE
FH BF: invalid characteristic curve, no Standardisation available
03009C FH BF: No Initialisation because of invalid marginal condition
E58468 BODY CAN Bus Control Module OFF
18 Transmission Control Module Codes
421402 No description available
420665 No description available
420664 No description available
420662 No description available
420661 No description available
CF2102 No description available
CF2101 No description available
CF2103 No description available
421031 No description available
421042
HISTORY
No description available
345042
HISTORY
3550CF
ACTIVE
No description available
B150CF
HISTORY
No description available
B250CF
HISTORY
No description available
B35041 No description available
CF1543 No description available
02FF18 No description available
CF0BFF No description available
Would appreciate any help. Thanks in advance
|
Wrong thread dude. This is x7 lci reveal