Quote:
Originally Posted by roadkillrob
Readiness is not set and it says failed due to codes, so looks like you need to clear codes and then drive some more to set readiness. Readiness is a cycle, just driving 70 miles will not necessarily set.
clear the codes with the jb4, buy a $15 obdII scan tool that will read readiness, and then do the drive cycle.
Scan tool amazon this one works I have it
http://www.amazon.com/Autel-MaxiScan...=Acutely+ms300
Follow drive cycle, then confirm readiness with tool.
http://www.m5board.com/vbulletin/att...-procedure.pdf
In my case I cleared codes, got readiness, got it tested and a week later codes came back and had to adjust from 5 to 6 o'clock.
Good luck! |
Quote:
Originally Posted by zeel
Clear the codes. Then turn off autoclear. Then drive cycle for readiness.
|
Quote:
Originally Posted by Tiago@VRSF
Sounds like you have canclear/autoclear on. Disable that and let the simulator work its magic.
|
Perfect thanks for all the help! So I need to turn off auto clear, clear the codes and then do a drive cycle for readiness. Can I do the drive cycle and then clear the codes? Or does the drive cycle need to be done last