Quote:
Originally Posted by Almaretto
Quote:
Originally Posted by Xmel`
Should it be coded in diagnostic mode or something?
When I change the parameters the disclaimer stays always ON not even default 3-5 sec.
And the mirror angle stays the same on whatever settings.
G05 2019 11/2020.xx
|
I always code with engine running (unless applying change to engine ECU).
Failure to observe change could be user error or mapping issue. I just coded both on three different cars and it worked. |
Exception is cars (S18A?) with DSC VIP2 (istep 11/2019 and later). Can only be coded in diag mode. Same for EPS ECU