BMW M3 and BMW M4 Forum - View Single Post - Hoosier 285/30X18 on Apex EC-7 18X10 ET43 Wheel

Flying Low · 02-05-2015, 11:16 PM

Just test fit this on the front of my M4. With a 15MM spacer and ET43 offset, I have a little less than 1/8 inch clearance between the strut and the side wall of the Hoosier with the BMW adaptive suspension. Is this enough clearance? The Hoosier is built up a little, close to the wheel like a bit of curb protection. Clearance looks good everywhere else but a bit tight at the fender lip (which is actually quite a way up due to the smaller diameter tire), but camber plates should take care of that.

Thanks,
Terry

02-05-2015, 11:16 PM	#1
Flying Low Private First Class 85 Rep 120 Posts Drives: 2002 M3, 2003 M3, 2015 M4 Join Date: Jan 2015 Location: Santa Rosa, CA and St George, UT iTrader: (1)	Hoosier 285/30X18 on Apex EC-7 18X10 ET43 Wheel Just test fit this on the front of my M4. With a 15MM spacer and ET43 offset, I have a little less than 1/8 inch clearance between the strut and the side wall of the Hoosier with the BMW adaptive suspension. Is this enough clearance? The Hoosier is built up a little, close to the wheel like a bit of curb protection. Clearance looks good everywhere else but a bit tight at the fender lip (which is actually quite a way up due to the smaller diameter tire), but camber plates should take care of that. Thanks, Terry
	Appreciate 0 Tweet Quote