Quote:
Originally Posted by aaroncw
Just did a replacement on the chrome ring that surrounds the iDrive knob. Super easy. Thought I'd document it, I know it's been done other places better, but it is a fun and easy 15 min project.
Hopefully the pics tell the story.
1. Use a plastic pry tool to pry up console trim. In my case the faux wood tone plastic. I started from back near armrest.
2. You don't need the trim all the way off. Just enough to remove controller. There are six clips on each side of controller holding it to trim. Very gently use a flat tool to release the clips. The controller will pop down when all clips are released with very little force.
3. Now you can raise the trim and bring the controller out, the wire is still attached so don't yank it.
4. There are 4 tiny pegs holding the trim circle down over the knob. Just put your flat tool down under the ring and gently pry it up over the pegs. Very easy, practically zero force required.
At this point the old ring is off. Put the new ring on. Make sure it goes over pegs secure. Now just reverse procedure. Pop controller back up into trim and make sure it clips right and is solid. When putting your trim back start from the front near stereo and gentle push it back into place.
This is my first project completed. Thanks to Bimmerpost and M3 for the how to.
|
You give me a new idea for personalization,THX