Quote:
Originally Posted by KD07
Just wanted to get some input from those that have installed the downpipe themselves. Any advice or things I should know about before trying to do it myself at home without a lift? I would be going catless, so anything I need to do or buy extra for the O2 sensor? I have a jb4 to clear the code so not worried about that. Probably will be going with the VRSF 4.5" simply because it's the lowest priced one.
Thanks, anything you can tell me is appreciated.
|
It can be done but a lift will make your life easier
Here is a review we got today
Mike was very helpful getting my order in. The JB4 and BMS intake take a whole 5-10 minutes to install. Intake makes a noticeable whistle by itself, but the JB4 unleashes the beast with the b58.
Catless downpipe was difficult to install on the ground. Ended up taking it to a lift to finish the install. Had to remove the center brace of the car to drop the exhaust enough to slide it onto the downpipe. Pro tip for install: remove the air box and loosen the vband and remove the sensors and bolts from up top. Much easier to remove the nuts and bolts from above.