[mds82]

Originally Posted by wj4

Maybe he wet the surface before applying the vinyl and used something like a credit card to squeeze out the water from underneath to avoid bubbles? At least this is what I've seen done on big stickers/vinyls on cars (to avoid bubbles under).

I went the opposite route as the OP. I also have poplar/beige. I went with a carbon fiber replacement fit about 2 years ago and got bored of it. Switched it back to poplar last week.

i sure hope he didnt wet things first!!!!! the 3M glue will never work right if there was water used underneath.



Honestly - i would re-do a lot of it. i can see lots of spots around the edges that are not tight.

Its a good start

[phattbam]

Originally Posted by ylincooper

Geez.. Thats the worst work ive seen all week

that's a bit harsh.. it's not that easy and maybe he didn't have much time.