04-09-2021, 01:32 PM | #1 |
Private
74
Rep 71
Posts |
"Stabilizer bar failed" after programming
Featured on BIMMERPOST.com Now they tell me that my Stabilizer bar failed after programming and it also needs to be replaced. Is this a thing? Can someone give me some insight about this? Thank god its only 2500 miles and under warranty but my patience is going to thin out soon. |
04-09-2021, 04:25 PM | #2 | |
Brigadier General
4365
Rep 4,246
Posts |
Quote:
There are two types of EPS on X7, with (variable rack geometry) and without (conventional) IAS. Error could be from IAS and performing a wheel alignment. There are carrier plates on the rear axle slip angle control (HSR) that shouldn't be undone.
__________________
Current BMWs - '20 X5 xDrive40i M Sport, '20 BMW M550i | Past BMWs - '03 E39 540iT M Sport, '06 E53 4.8is, '11 E70 M Sport LCI
|
|
Appreciate
1
Greg-BimmerX773.50 |
04-09-2021, 08:12 PM | #3 |
Captain
716
Rep 782
Posts |
Just my opinion:
Cars are super f-ing complicated these days. As complications increase, so will difficulties with technology. As long as it eventually gets fixed and the dealership provides a loaner or some compensation, no big deal. Don’t even ask me what happens when a new F-35 gets delivered from the factory. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|