03-27-2024, 03:09 PM | #1 |
New Member
9
Rep 19
Posts |
ista+ programming with ENET cable
From searching it looks like the KL30 voltage monitoring when programming in ista+ is only possible with ICOM. So with ENET, I see “KL 30: -“ in the software.
If I set my PSU to say 12V, I get a message in ista+ "The battery voltage (terminal 30) is below the permissible threshold value of 12.55V", but don't get such message when it's at 13.8V. So I think my question is, am I good to go if ista+ doesn't pop up warning? Last edited by peteryu1131; 03-28-2024 at 07:32 AM.. Reason: fix image url |
05-08-2024, 08:37 PM | #2 |
Enlisted Member
20
Rep 42
Posts |
Probably a question for Bimmer Scene...
__________________
20 ///X5MC Tanzanite Blue II Metallic - RachChip, MSS Springs, Cat-back Titanium Exhaust
17 X5 50i Space Grey Metallic - ESS Tune, Catless Downpipes, X5M Air Filters, H&R Springs & Spacers , BBK 96 SC ///M3 Racecar - CP Pistons & Rods, ARP Studs, VAC SC Cams, VF V3 Blower, 12lb Pulley, RK Tune & lots, lots more... |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|