07-03-2016, 01:18 PM | #1 |
Second Lieutenant
43
Rep 201
Posts |
chassis stabilization reduced after fuse check
I was going through the fuses in my X5 trying to trouble shoot my lift gate issue and I think I pulled / replaced a fuse I shouldn't have.
The next time i started my 2010 X5d the chassis stabilization reduced 4x4! warning came on. I have done a lot of searching and tried the "turn the wheel full left and right" and it still doesn't fix the issue (possibly doing it wrong?) Anyone have any thoughts? Anyone know the exact fuse this was so I can check it is in right place or not blown? Thank you! |
07-03-2016, 04:37 PM | #3 |
Second Lieutenant
43
Rep 201
Posts |
|
Appreciate
0
|
07-09-2016, 08:32 AM | #5 |
Second Lieutenant
43
Rep 201
Posts |
I checked the codes
6EC4 DSC Steering anhle sensor adjustment Err will cause a warning light error is not currently present test conditions have been completed 6F8C DSC: No PT-CAN (FRM,1E1) Error will cause a warning light Error is not currently present Test conditions have been completed 5F3A DSC Transfer case and special transmission: Malfunction Errror will cause a warning light error is not currently present test conditions have been completd |
Appreciate
0
|
07-09-2016, 08:52 AM | #7 |
Second Lieutenant
43
Rep 201
Posts |
I am still feeling this is a fuse issue, as this started when I was taking fuses out. Is there a way to figure out which fuses should be installed and which should not be? I was dumb and did not talk a picture before hand.
|
Appreciate
0
|
07-09-2016, 09:37 AM | #8 |
Second Lieutenant
43
Rep 201
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|