12-22-2019, 09:29 AM | #1 |
First Lieutenant
181
Rep 310
Posts |
F82 Harness Install
I've been doing a ton of research and think I've settled on the right half cage (Bimmerworld). I am struggling to figure out the best seat and harness combo though. My first concern is not having to drill a bunch of holes in my car. Also, isn't the subwoofer in the way when installing the anti-submarine straps? Is there a way to keep the stock seats, or will I need to replace them both? I don't care about the rear seats as they've never been used.
Edit: I am planning to use the Z-Tech 6a head restraint. |
12-22-2019, 12:19 PM | #2 |
///M Powered for Life
11500
Rep 10,333
Posts |
I suggest you go with Brey Krause seat mounting hardware.
It allows you to retain the oem slider which is significantly better than any other one as well as keep your 3 point oem belts along with the 6/7 point The install is fully reversible and requires no additional drilling The subwoofer is not in the way of the BK solution. I'm not sure what you're asking about the stock seats |
Appreciate
0
|
12-22-2019, 12:30 PM | #3 | |
Banned
1194
Rep 3,670
Posts |
Quote:
|
|
Appreciate
0
|
12-22-2019, 01:14 PM | #4 | |
First Lieutenant
181
Rep 310
Posts |
Quote:
The BK solution is just a seat mount that uses the factory rails? Their website is kind of useless. The Bimmerworld cage uses stock mounting points and is fully reversible if you remove the rear carpet instead of cutting it. |
|
Appreciate
0
|
12-22-2019, 02:56 PM | #5 | |
///M Powered for Life
11500
Rep 10,333
Posts |
Quote:
A 6 point harness connects to: -2 shoulder belts through the seat and connects to the 4 point cage (or a harness bar) -2 lap belts that go through the seat and connect to the aftermarket seat mounts -2 sub belts that go into the seat and to the antisub bar that also connects to the seat mounts BK makes seat mounting hardware that lets you run the 6 point and the 3 point for street use, lets you reuse stock sliders and also mounts a sub bar without having any permanent modifications. |
|
Appreciate
1
Kev608180.50 |
12-22-2019, 03:22 PM | #6 | |
First Lieutenant
181
Rep 310
Posts |
Quote:
|
|
Appreciate
1
SYT_Shadow11500.00 |
12-28-2019, 07:31 AM | #7 |
Captain
412
Rep 737
Posts |
The stock seats don’t have shoulder harness through holes so you would not even be able to use a 4pt harness. The first thing that has to change is the seats. Then you can go 4pt quick fits. Or 4pt with harness bar. Then you could go with 6pts and add a roll bar later.
|
Appreciate
0
|
12-28-2019, 09:15 AM | #8 | |
First Lieutenant
181
Rep 310
Posts |
Quote:
Last edited by Kev608; 12-29-2019 at 01:07 PM.. |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|