|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Bms catch can
|
|
07-08-2014, 12:38 PM | #1 |
First Lieutenant
20
Rep 352
Posts |
Bms catch can
I installed one 10k miles ago, just went to drain it and only had a few drops in it. Is that normal? I have also installed about 5k ago the RB pcv valve.
|
07-08-2014, 01:11 PM | #2 |
Major General
456
Rep 6,478
Posts |
Just means the crankcase is venting properly and not blowing too much crap back into the rear inlet. You can thank Rob's valve for that.
My OCC has been on for like 10K at this point, I looked at it this weekend and it wasn't more than maybe 1/5th of an inch or so. Barely a pool at the bottom of the canister.
__________________
E88 N54 Alpinweiss/Coral Red/Motiv HTA 3586r Tial .82AR/Other stuff...652WHP
F30 N55 XDrive EBII |
Appreciate
0
|
07-08-2014, 08:43 PM | #3 |
2095
Rep 43,350
Posts |
Not terribly uncommon, especially with cars in consistently warmer climates. I've noticed the most amount of oil in our catch can when I go for short drives before the car has a chance to fully warm up.
|
Appreciate
0
|
07-09-2014, 02:49 PM | #5 |
Joint Chiefs of Staff
4918
Rep 115,980
Posts |
It depends on your driving habits and there is a lot of in car variability. Some guys have tonnes of oil in the can, and some have none.
Mike |
Appreciate
0
|
07-09-2014, 11:14 PM | #6 | |
BimmerPost Supporting Vendor
24199
Rep 190,807
Posts |
Quote:
thats normal
__________________
Check out our current sale by clicking on this link!
https://x-ph.com/sale/ Phone number 702-494-9435 |
|
Appreciate
0
|
Bookmarks |
|
|