[TacoCodeRed]

I have it set so when Im in a map it shows boost and meth flow. This works fine but when I change back to Map 0 the gauges do not go back to fuel and oil temp until I turn off the car.

I tried to set the option for gauge hijacking when the pedal is >50% (5/6 in the menu) and it screwed all the needles up. I had to do a cluster reset and a 335 calibration to get it to go back to normal.

Any ideas for either problem?

[Jeef]

5/6 is not the config gauges for our cars. its 5/2. also to turn on the 50% pedal its 4/1

[TacoCodeRed]

then what the hell kind of spreadsheet was i looking at...

[TacoCodeRed]

i must have downloaded an older wheel control spreadsheet on my phone and was referencing that... just got the new one. dumb moment.

although dont think thatll answer the question of why it wont go back to stock gauges when i go back to map 0