|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
E90 Rear Electric Roller blind coding with SSS - Problem
|
|
03-15-2015, 04:26 AM | #1 |
Captain
137
Rep 859
Posts |
E90 Rear Electric Roller blind coding with SSS - Problem
I fitted a rear electric roller blind and coded it with the SSS V32, but it doesn't work. I have tested it by connecting a battery to the two wires running from the blind to the JBE and the blind works, but it doesn't work when I press the button.
I have also doubled checked the pin ins in the JBE, 3 and 30 from memory. However the only thing I find strange is that when coding it doesn't appear to have coded the centre switches as shown below. I haven't tried coding the switches separately Any clues? |
03-15-2015, 05:59 PM | #2 |
Lord Scrip
1815
Rep 3,013
Posts
Drives: 2011 M3 Coupe
Join Date: Jan 2012
Location: LA,Ca
|
I've never used SSS but with NCSExpert I have to update VA for FRM, CAS and NFRM. If I only do 1of3 or 2of3 the car removes it after going to sleep. But when I FA wrote to all 3 modules my coding stays. So if SSS doesn't update all VO holding modules then it will remove itself because all VO's don't match. Same thing goes if I don't update VO at all and just modify the parameters of the modules directly......programming is removed if battery is removed for service or I do an SG_reset. But modifying the VO in the 3 modules is a permanent setup. Hope this helps!
__________________
|
Appreciate
0
|
03-17-2015, 02:48 AM | #3 |
Captain
137
Rep 859
Posts |
I am still unsure of the issue, as when I go to activate the blind with the BMW DIS software (which bypasses some modules) it doesn't work, yet I know my wiring is as per the EBA and that it works when I manually feed power to the two wires that run to the blind.
|
Appreciate
0
|
03-23-2015, 03:55 AM | #4 |
Captain
137
Rep 859
Posts |
The issue appears to be that I need to change the standard Junction box which the EBA instructions only briefly glosses over in the introduction. Once I do this and recode, I will report back.
|
Appreciate
0
|
Bookmarks |
|
|