[ajfoggy]

Hi Just wondering if anyone can post a few close up pics of the carbon performance splitters fitting in the m sport bumper around the fog light housing please.

Got mine today from states and just want to compare how well it fits.

[Sebilad]

Not the best but hope that helps a litte

[ajfoggy]

Originally Posted by Sebilad

Not the best but hope that helps a litte

Thanks but need a little closer in try to see what the gap is like where it covers the existing bumper with the edge to the fog light insert.

[ajfoggy]

Originally Posted by Sebilad

Not the best but hope that helps a litte

Actually don't worry I can see from that picture now. The red strip between the fog light housing and the carbon. I have a blue strip, funny the official BMW installation instructions say that that think strip should be coloured in black prior to fitting... not sure what with though. It mentions a black paint pen.

[Sebilad]

I know what you mean, I've seen various ways of it been done, unless it's done absolutely perfectly with like a black piece of vinyl it looks better without. Slightly different splitter but obviously there's no white gap between the fog light trim and plastic splitter

[ajfoggy]

Hmm, i'm wondering how to fit mine now....

[snipnoob86]

Originally Posted by ajfoggy

Hmm, i'm wondering how to fit mine now....

sharpie it!

on a serious note use a strip of vinyl gloss / carbon or matt black before fitting

[ajfoggy]

Been reading all about this betalink adhesive that BMW use. Don't fancy that much so going to go for 3M tape but cannot work out which one I need. Think it's 3M PT1100 Acrylic Plus.

Going to use it on splitter and spoiler.