|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Can i use a 330i spec clutch/pressure plate/flywheel in a 328i?
|
|
11-29-2015, 12:05 PM | #1 |
Emperor
1614
Rep 2,753
Posts |
Can i use a 330i spec clutch/pressure plate/flywheel in a 328i?
If so, what other parts (if any) do I need to make it work?
Is a different flywheel required or can the 328i flywheel be reused (assuming it's not damaged when I get in there)? What else should I be getting for while I'm in there? Rear main seal, pilot bearing, pivot pin? Looking at realoem, the tranny in the 328i is a different PN than the tranny in the 330i-- no issue with the different clutch disk? Thanks!
__________________
2005 M3 Coupe, 2004 M3 Wagon, 2001 M5 Sedan, 2008 M5 6MT Sedan, 2012 128i M sport Last edited by Obioban; 11-29-2015 at 12:35 PM.. |
Bookmarks |
|
|