[JohnL135I]

How do I manually load Map 2 or Map 1 in the Procede software?

Also, what should Valet be set at and what does this do?(does valet default to map 1?)

Thanks.

[OpenFlash]

Originally Posted by JohnL135I

How do I manually load Map 2 or Map 1 in the Procede software?

Also, what should Valet be set at and what does this do?(does valet default to map 1?)

Thanks.

Set valet to 300rpm (default setting). This basically makes sure the procede is always on when the car is running.

As for map loading, I assume u are running v3. If so, you don't need to load map 1 or map 2 separately. Each map file contains both maps. Map1 is always the lower power map. Map 2 is always the higher power.

The PROcede will default to Map1 (lower power ~10-12psi). To activate the full power map (13-15psi) map, just press the Green button on the keyfob.

Shiv

[JohnL135I]

Originally Posted by shiv@vishnu

Set valet to 300rpm (default setting). This basically makes sure the procede is always on when the car is running.

As for map loading, I assume u are running v3. If so, you don't need to load map 1 or map 2 separately. Each map file contains both maps. Map1 is always the lower power map. Map 2 is always the higher power.

The PROcede will default to Map1 (lower power ~10-12psi). To activate the full power map (13-15psi) map, just press the Green button on the keyfob.

Shiv

I have a 135i, My keyfob has 3 buttons on it...none are green.

I just started my car and opened my procede software, my map was 2.000(which it is suppose to default to), however, with in 2 seconds it went right back to map 1.000. I do not have homelink so I believe the procede should default to Map 2. My procede is not defaulting to Map 2.... need help.

[OpenFlash]

Originally Posted by JohnL135I

I have a 135i, My keyfob has 3 buttons on it...none are green.

I just started my car and opened my procede software, my map was 2.000(which it is suppose to default to), however, with in 2 seconds it went right back to map 1.000. I do not have homelink so I believe the procede should default to Map 2. My procede is not defaulting to Map 2.... need help.

Oh wait. I was talking about the mapswitch keyfob, not the BMW keyfob. I think I'm responding to your email right now.

shiv

[JohnL135I]

problem solved, thanks Shiv....