10-05-2019, 11:16 PM | #1 |
New Member
10
Rep 23
Posts |
ITSA+ Install Problems
Hey everyone, I wanted to throw this up just in case anyone has the solution to my issue. I installed ISTA+ according to instructions that I found on the forum as close as I could, I installed version 4.15.16.
When I launch Ista+ using the TesterGui file I am told that "Failed to start ISTA. Please make sure your ISTA configuration is valid. In doubt reset any non standard ISTA configuration and reinstall ISTA." If anyone has any experience with this I would love to hear any and all solutions. I am midway through retrofitting from TCB to ATM and want to double check the gauges of wires from NewTis. I attached the log down below. Thank you! |
10-06-2019, 10:24 AM | #3 |
New Member
10
Rep 23
Posts |
|
Appreciate
0
|
10-03-2020, 09:30 AM | #5 |
New Member
0
Rep 10
Posts |
i have a similar problem going through the install steps im up to clicking on the desktop short cut it starts to spin mouse pointer then nothing happens, i did it as administrator have done all the steps prior loaded on laptop with window 10 x64 if anyone can help??
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|