|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Car dying after fuse change
|
|
04-02-2020, 08:25 AM | #1 |
New Member
0
Rep 8
Posts |
Car dying after fuse change
I was wiring in dashcam today and afterwards the car would not start without a jump start, then I took it for a short drive.....after that car would not start again and completely died just after a jump start. I only had one fuse tap so wrapped a wire round the radio fuse...
car has been fine up until now , what could I have done All fuses arent blown and are in the correct place |
04-02-2020, 08:32 AM | #2 | |
New Member
0
Rep 8
Posts |
Quote:
1) wired dashcam, car needed jump start as "totally dead" no electronics etc 2) car jumped and driven few miles, wont start 3) second jump start car starts then dies straight away 4) after removing and replacing the negative battery cable car starts and drives fine....removed dashcam wiring for now |
|
Appreciate
0
|
Bookmarks |
|
|