06-12-2020, 06:02 PM | #1 |
New Member
0
Rep 6
Posts |
323i stalls when hot
Very odd behavior.
2009 - 323i - 197,000km runs well for days and then it stalls. I have to wait 30, 40 mins to cool down and then it runs again for a while. I disconnected the MAF sensor and runs for ok (a bit rough and revs up and down 500 - 900) then the same results. The error codes I get are mainly from the ECU 2A38, 2A32, 2A31. P1030, P1014. P1030, P1006 eccentric shaft sensor ? valvetronic shaft sensor? Is this something I can change/repair without too much fuss? Or is this a garage bound repair? I have moderate experience but not an extensive set of tools. Any suggestions? |
Post Reply |
Bookmarks |
Tags |
323i stalls |
|
|