|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Stett charge pipe install question
|
|
09-29-2009, 11:59 PM | #1 |
Major
57
Rep 1,193
Posts |
Stett charge pipe install question
Im having trouble aligning the sensor with the charge pipe. It seems that the sensor wont reach to the pipe at all and Im afraid I will put too much pressure on the wires and break it. Any help would be appreciated.
__________________
|
09-30-2009, 06:34 AM | #2 |
Major General
307
Rep 5,175
Posts |
From my experience that seems almost impossible. Are you connecting the TMAP first, installing the pipe, then connecting the TMAP wire harness?
|
Appreciate
0
|
09-30-2009, 07:11 AM | #3 |
Burrito bowl connoisseur
124
Rep 3,501
Posts |
when i installed mine this past weekend: 1) i bolted the sensor down on the pipe 2)installed the pipe 3)then connected the wire harness to the sensor. there was very little play with the wire harness...but it did connect without a problem.
|
Appreciate
0
|
09-30-2009, 09:47 AM | #4 |
"Booty Hole Bandit"
32
Rep 1,597
Posts |
You gotta push the charge pipe further into the throttle body boot...it'll give you an 1"-2" more clearance to plug in the tmap sensor. Happened to me...just use a little windex to lube the area where the charge pipe goes into the throttle body boot, makes it easier to maneuver. Hope that helps!
|
Appreciate
0
|
Bookmarks |
|
|