[HomeBrew]

I just installed a dension gateway 500 with bluetooth (bta-1500).

I need the phone functionality enabled in order to use the hands-free functions of the dension.

Does any one know the codes/values to enable the phone functionality? I've found a few codes which may do it, but I'm not sure. I looked through the spreadsheet as well with no luck.

Maybe it's an option code for the VO - K K638 TEL_PROFESIONEL / / retrofitting Car telephone Professional ?

Thanks,

Chris

[JTRACKER]

I'm also looking for the same - just reviving this post.

[ctuna]

Did you happen document your Denison DIY.
At least the coding part ?
Did you just add the CD changer to both the CAS and Frm module.
did you have to process the entire car afterwards?

wouldn't the denison bluetooth/telephone be on its own hardware and not relate to the
car software or hardware.
I would call denision on that.

[HomeBrew]

Originally Posted by ctuna

Did you happen document your Denison DIY.
At least the coding part ?
Did you just add the CD changer to both the CAS and Frm module.
did you have to process the entire car afterwards?

wouldn't the denison bluetooth/telephone be on its own hardware and not relate to the
car software or hardware.
I would call denision on that.

I was never able to get the phone functionality of the Dension working.

Per the Dension doc's, the phone functionality of the vehicle needs to be enabled (programmed).

I purchased my Dension Gateway 500 with a programmer (from Enfig Care Stereo in NJ). However, I reinstalled it in my trunk and programmed it via NCSExpert, etc.

I didnot reprocess the whole car, just enabled the VO code for the cd changer and programmed appropriately.

[ctuna]

http://www.e90post.com/forums/showthread.php?t=85149

Maybe there are some clues in the above thread.
Does the Denison phone module actually have a connection to the Most Bus?
In the BMW retrofit guide there is some rearranging of the Most bus Hub behind the
rear passenger seat US drivers side seat bolster.