09-07-2013, 01:40 PM | #1 |
Second Lieutenant
16
Rep 281
Posts |
plasti dip rocker panels on M-Sport...
instead of the M Performance film...
going to try it out on my mineral grey hopefully tomorrow if its nice out...I already prepped them cleaned them of all the wax so the paint will bond good. pictures to come soon. |
09-08-2013, 10:50 AM | #2 | |
Private First Class
14
Rep 180
Posts |
Quote:
|
|
Appreciate
0
|
09-08-2013, 05:10 PM | #3 | |
Second Lieutenant
16
Rep 281
Posts |
Quote:
you have to be very good at taping bc you have to lay down on your side to tape it if you kneel or try to sit you are not looking at the rocker straight on which makes it extremely difficult being you want a perfect line. My one side is identical to the M performance decal. So I have to re tape the passenger side and start over...wasted 5 coats on that side too will keep you updated, also when I started spraying of course the wind picked up exceptionally making me spray then stop and waiting for it to die down, meanwhile all morning it was nice and calm out lol |
|
Appreciate
0
|
09-11-2013, 05:51 PM | #4 |
Second Lieutenant
16
Rep 243
Posts
Drives: 2013 335i M-sport
Join Date: Mar 2013
Location: Georgia
|
Can the job be done if you already have the Side Skirt Blades installed?
|
Appreciate
0
|
09-11-2013, 06:14 PM | #5 | |
Second Lieutenant
16
Rep 281
Posts |
Quote:
I just finished it yesterday...weather pending couldnt do it all in one shot...I have all the pics of how I did it and finished product |
|
Appreciate
0
|
09-12-2013, 08:44 AM | #7 | |
Second Lieutenant
16
Rep 243
Posts
Drives: 2013 335i M-sport
Join Date: Mar 2013
Location: Georgia
|
Quote:
|
|
Appreciate
0
|
09-12-2013, 01:59 PM | #8 |
Second Lieutenant
16
Rep 281
Posts |
|
Appreciate
0
|
09-12-2013, 08:42 PM | #9 |
Second Lieutenant
16
Rep 281
Posts |
ok here are the pics...prep pics and pics of progress and final product.
Tape off directly on top of the outline on the skirt... continue along but be careful as the line to follow is very hard to see once you get around where the rear door meets the front door...step back get as low as you can and eyeball it from several angles, you can always adjust tape. As you can see mine is a tad off there but I cover it up later with newspaper. Newspaper and sheet were for possible overspray even though it is plasti dip and you can peel it off easily but just didn't want any little speckles getting anywhere. And don't hate on the mickey sheet lol Start spraying from one end to the other holding can 6-8inchs away, this was my first base coat, which should be light. After that first light coat, wait about 20-30minutes before applying each coat(the can says 4 hours between coats, no way was I doing that) you can start applying full coats not too heavy in one spot and work on getting the top or bottom portion of the skirt first as the spray will not cover entire skirt, then go back and do the same for the next section. Also want to make sure you get underneath slightly. this was my 3rd coat, 2nd full coat not counting the first base coat... progress on 4th coat, 3 full coats... 5th coat, 4 Full... and that's where I stopped. You can do as much or little as you like its personal preference to as how light/dark you want it. now I just removed the newspaper first and left the green tape on for about 2-3 hours to make sure that it dries. Because I made the mistake of taking the green tape off maybe 20 minutes after and the tape pulled some paint off on rocker so I had to peel it all off and do it over. Could not cover it up with paint I tried and it didn't look right for me. ok so after you wait a few hours, you can start peeling the green tape off but another tip, don't just pull it off fast, keep slight pressure on tape and pull in upward angle not just straight across watching the tape as coming off. and that's it guys, pretty simple and If you do mess up or don't like it just peel it off. Enjoy |
Appreciate
1
|
09-12-2013, 10:37 PM | #11 |
Second Lieutenant
16
Rep 281
Posts |
it don't pop on mineral grey like say on white blue or red but you can def see it in person better then the pictures...thanks
Last edited by steveMizdaman; 09-12-2013 at 10:59 PM.. |
Appreciate
0
|
09-13-2013, 03:45 PM | #13 |
Second Lieutenant
16
Rep 243
Posts
Drives: 2013 335i M-sport
Join Date: Mar 2013
Location: Georgia
|
Looks good, nice job! I'll have to give it a try!
|
Appreciate
0
|
09-13-2013, 04:53 PM | #14 |
Second Lieutenant
16
Rep 281
Posts |
|
Appreciate
0
|
09-14-2013, 11:24 AM | #16 |
Second Lieutenant
16
Rep 281
Posts |
|
Appreciate
0
|
12-09-2014, 12:36 PM | #18 |
Lieutenant Colonel
309
Rep 1,748
Posts |
No hate on the Mickey sheet itself....but why ruin it?!? That's a cool looking sheet.
I'll be honest, I expected it to look like crap, but it looks good! Is your front lip also dipped? |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|