|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Datalog Review Please
|
|
06-08-2014, 05:33 PM | #1 |
Enlisted Member
7
Rep 26
Posts |
Datalog Review Please
Hey everyone. I'm pretty new to the forum. I've had my car since this past September. The car has run flawless since. The car came with an Injen DCI. Last week I installed VRSF catless DP's and Openflash Tablet.
On the stock tune the car still ran perfectly after the flash. Once I installed the Vishnu OTS map stg 0, the car ran just fine until WOT and full boost was achieved. Once I'd go WOT the car would stutter and break up terribly and immediately go into limp mode. I also had a cyl 2 misfire code. So I swapped the plugs out today. The car now pulls to redline without breaking up and is much smoother. However now the car seems to pull with a very uneven feeling torque curve. I ran a log and was hoping it may be sufficient for some feedback from yall. Thank you. http://www.datazap.me/u/rxbandit/stg...log=0&data=1-3 EDIT: Here is another run I did. Felt slightly better. http://www.datazap.me/u/rxbandit/stg...log=0&data=1-3 Last edited by RXbandit; 06-08-2014 at 05:59 PM.. |
Bookmarks |
|
|