|
|
03-02-2017, 02:54 PM | #1 |
Captain
94
Rep 661
Posts |
Oxygen sensor break after installing test-pipe
Background: I purchased evolve tune(stage 2) along with their test-pipe, installed the test pipe on 11/2/2016 and did the tune a few days later. Before I installed the test pipe, I had challenge street xpipe.
Everything was great until last week, the "service engine soon" went on and I checked the codes it was about the rear oxygen sensors so I ordered a set of rear o2 sensors and replaced them today. After driving for 25 mins, the service engine soon light went back on again, expect this time the code's about one of the front o2 sensor (2749 oxygen sensor before cat). A friend of mine has a similar problem after installing a test pipe, except his service engine soon light goes on and off, mine is constantly on. So is this considered normal? If it's normal, I might just leave the light on although it annoys me. What are some other options? Thanks in advance.
__________________
11 E92 M3 DCT | Evlove Stage 2 Tune | Evolve Test Pipe | Akrapovic slip-on | MS Stage 2 Intake | Ohlins R/T | Vorsteiner VFF-101 | OSSdeisgns | Exotics Tuning
|
03-02-2017, 03:54 PM | #2 | |
Major
404
Rep 1,171
Posts |
Quote:
|
|
Appreciate
1
Locksmythe48.00 |
03-02-2017, 04:35 PM | #3 |
Captain
94
Rep 661
Posts |
Thx for the advice, didn't think about that
__________________
11 E92 M3 DCT | Evlove Stage 2 Tune | Evolve Test Pipe | Akrapovic slip-on | MS Stage 2 Intake | Ohlins R/T | Vorsteiner VFF-101 | OSSdeisgns | Exotics Tuning
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|