05-15-2017, 07:27 AM | #1 |
\\\M Power
3
Rep 14
Posts |
CEL with a DME code 105201 on JB4 (S55)
Hello!
Maybe someone can help me I use JB4 on map 1. From other mods only BMC intake filters. All worked perfect for me. But from 2 weeks ago I start get CEL with a DME code 105201 / Ambient Pressure Sensor (pressure too high). What can be wrong? After dell all DME failure codes it can come again after 1 or 2 cold starts. Thank you for help! P.S. And no so important question. Can JB4 remember valves exhaust position if i use map 0 (all pass thru). My JB4 remember it only when I use Map 1. Or I have to use Map 4 for stoke performance and valves open? Last edited by BMW_M4_333; 05-15-2017 at 08:16 AM.. |
05-15-2017, 06:31 PM | #2 |
BimmerPost Supporting Vendor
24199
Rep 190,807
Posts |
I recommend you contact BMS technical support for best help
__________________
Check out our current sale by clicking on this link!
https://x-ph.com/sale/ Phone number 702-494-9435 |
Appreciate
0
|
05-16-2017, 12:07 PM | #4 |
Lieutenant
136
Rep 498
Posts |
I received the same code a few weeks after I installed my JB4. It did go away after a few drive cycles. It hasn't returned since. I didn't investigate it further since it went away the same day.
|
Appreciate
0
|
05-17-2017, 06:08 AM | #5 | |
\\\M Power
3
Rep 14
Posts |
Quote:
Do you have any other mod? Map 1? Last edited by BMW_M4_333; 05-17-2017 at 06:14 AM.. |
|
Appreciate
0
|
05-17-2017, 12:11 PM | #6 |
Lieutenant
136
Rep 498
Posts |
|
Appreciate
0
|
07-12-2017, 02:11 PM | #7 | |
\\\M Power
3
Rep 14
Posts |
Quote:
Thank you. |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|