Please help Failure Code

[Ghostcrazy]

Good friends.

I just registered and am new to this forum, but I am looking for help due to several bugs that I am not able to solve.

These errors that I have after passing a diagnosis with Carly


Roof control panel
Failure code: 801A4A Car alarm: Tilt sensor disabled and interior protection / IRS disable and tilt sensor based on customer function


Rear seat (driver's side)
Failure code: 802A1E No seat adjustment due to engine start condition

Telematics
Failure code: B7F32B Telematics antenna 1: interruption / Internal control unit hardware fault / GSM antenna: interruption

Thanks in advance

[Thewrench86]

The tilt sensor may just need to be reset. There is a specific procedure you need to follow. Let me try finding it.

[Thewrench86]

push and HOLD continuously, the sunroof button up (vent position). After about 15-20 seconds, the sunroof will vent. CONTINUE HOLDING THE BUTTON UP. After another couple of seconds, 15 or so (could feel long, but keep holding) , the sunroof will close, then open completely, then close completely.

[Ghostcrazy]

Originally Posted by Thewrench86

push and HOLD continuously, the sunroof button up (vent position). After about 15-20 seconds, the sunroof will vent. CONTINUE HOLDING THE BUTTON UP. After another couple of seconds, 15 or so (could feel long, but keep holding) , the sunroof will close, then open completely, then close completely.

Thank you very much for your answer, but my vehicle does not come equipped with a sunroof.

[Thewrench86]

🙃 my bad