EAS CF Hood Vents Install

[NugeMobile]

Can anyone point me to any write-up/advice on this? I know it's extremely straightforward and I've completed more complex mods, but anything involving "snapping out" a part next to the actual finish/clearcote on the car is always worth some insights before diving in.

Thanks - and yes I did search around the forum and couldn't find anything.

Best,

B

[Moxie]

http://www.m3post.com/forums/showthread.php?t=233339

I did it last night - Pretty easy. You'll see everything when you take off the rubber grommet under the hood.

Originally Posted by nkweisberg

Figured out how to do it. Pull off rubber grommet from inside of hood. Take plastic wedge and going from the inside of the hood press up on the tabs holding the painted hood vent ring in place. Work your way around releasing all of the tabs. Then remove the hood vent from the outside but lifting up. Take out the black mesh inner piece and put this in the new vent surround. Then press it down into the hole in the hood until all of the tabs lock in place. Reinstall the grommet and repeat on the other side.

Just be careful releasing the tab so you dont snap any off.

[NugeMobile]

Thanks!!!