|
|
|
12-08-2012, 12:26 PM | #1 |
Lieutenant
35
Rep 550
Posts |
ER charge pipe/ codes
After installing the charge pipe in my 2011 135i, I am getting 2 codes on my P3 gauge. 29D0 & 29E0. They both are related to the intake air sensor. I haven't tried the P3 code delete process yet, I was just wondering if anyone has experienced this issue???
|
12-08-2012, 11:06 PM | #2 |
Private First Class
13
Rep 165
Posts |
Mine too has a code when I first start the car I have a ER charge pipe
__________________
BMW 135i Jet Black AT. Hpf intercooler, Hpf exhaust, injen intake, ER competition oil coolers, ER charge pipe, Tial BOV, AR catless DP,BMS OCC, VMR 718s 19s, BMW performance spoiler, agency power rear diffuser, slek lip (on highway somewhere), FXomar abs lip, Ohlins Suspension, All M3 bits, Cobb protuned, turner 3 clutch LSD, Escort 9500ci
|
Appreciate
0
|
12-09-2012, 11:18 AM | #3 | |
Captain
302
Rep 913
Posts |
Quote:
Codes on new parts are never normal.
__________________
2020 bmw xHippo, v8tt edition
|
|
Appreciate
0
|
12-09-2012, 12:08 PM | #4 |
Lieutenant
35
Rep 550
Posts |
O ring installed properly, had to use a tiny bit of Vasiline to help it in. All other connections were checked/ rechecked.I just don't see why I would get any codes at all??
|
Appreciate
0
|
12-09-2012, 07:10 PM | #5 |
Captain
302
Rep 913
Posts |
That should mean a leak in the intake somewhere. If you are hooking up to stock piping, check that you didn't overtighten the clamp on the silicone sleeve.
Also double check your maf sensor has its ring and is seated
__________________
2020 bmw xHippo, v8tt edition
|
Appreciate
0
|
12-09-2012, 10:19 PM | #6 |
Lieutenant
35
Rep 550
Posts |
Ok, I tried deleating the codes through the P3 and no dice. Went on a brisk drive and everything seems to be fine, car pulls hard and drives as usual. Just have the 2 codes showing on my P3 gauge. If these two codes were a serious malfunction, then woulden't the car go into some sort of a limp mode??
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|